Total:

FormPlate

FormPlate är framtagen för att klara de höga krav som ställs vid gjutning. Den är tillverkad av specielwell – ett biobaserat, nedbrytbart material som ersätter traditionella lösningar som trä, metall och fossilbaserad kanalplast. Resultatet är en kostnadseffektiv och en mer hållbar lösning som är snabb att montera, flexibel för olika fundament och ergonomisk att arbeta med. Du får ett material som sparar både tid och pengar, utan att lämna något efter dig i marken.

Biobaserat material och biologiskt nedbrytbart
Minst 50% återvunnet material
Snabb montering och flexibel
Kostnadseffektivt – halverad inköpskostnad jämfört med plast

Find dealer Högupplösta bilder

Design

Quantity

Unit

Price/unit

Price Information

Buy

Product Information

Application Area

FormPlate is intended to be used for creating a mold when casting foundations. The corrugated cardboard is water-resistant due to the surface treatment and can remain outside for up to two weeks before being filled. The mold must be backfilled before casting.

Installation

FormPlate is easy to handle and install and can be easily cut or folded to the desired size. The recommended fastening is mounting screw (min 40 mm), farmer screw (min 40 mm) or Screw and washer (TECCA art.no 296015). The board is mounted with a maximum of 400 mm between the fastening points in the foundation form's spacer strip. The casting board is easy to remove after casting but can also be left as it is biodegradable and decomposes.

Important!

Mechanical fastening is done with assembly screws (min 40 mm), farmer screws (min 40 mm) or alternatively screws and washers (TECCA art. no. 296015).
The product should be stored indoors or outdoors protected from precipitation.
When the disc is correctly mounted in the reinforcement cage (folded down at the top), it can remain outside for up to two weeks before being used for casting.
The mold must be backfilled before casting.
The casting board made from bio-based material decomposes and decays when left in the ground after casting.
The disc should never be folded more than double.
Always start the assembly at a corner.