Total:

TopTite 6

TopTite 6° är en självklistrande ytpapp som består består av en robust polyesterstomme, med goda styrkeegenskaper och hög dimensionsstabilitet. Asfalten innehåller SBS-elastomer, vilket gör att pappen är smidig och flexibel även vid låg temperatur. I pappens längdriktning finns den självklistrande kanten som är försedd med en skyddsfolie.

Down to 6° roof pitch
Self-adhesive

Find dealer Högupplösta bilder

Design

Quantity

Unit

Price/unit

Prisinformation

Buy

Product Information

Application Area

The surface felt TopTite 6° is intended for two- or single-layer covering of old and new roofs, with a slope of at least 6° (1:10). The ratio 1:10 means that the roof slope is one meter over a ten-meter length. The product is not suitable for roofs with internal drainage (roof drains); for this, a weldable waterproofing membrane is recommended. The roof area should not exceed 300 m² (in which case a welded waterproofing membrane is preferable).

Installation

The assembly can be done according to the Do-It-Yourself principle. Since the paper edges are self-adhesive, no special equipment is needed. On the inside of the cover, there are detailed instructions for covering the roof with TopTite 6°. For cross joints and other gluing, sealing adhesive K-36 or alternatively adhesive and sealing compound T-Fix is used. Read the instructions carefully before starting the work. At roof temperatures below +10°C, a hot air gun is used to activate the adhesive surfaces.

Nailing is done with roofing nails at least 25 x 2.8 mm (hot-dip galvanized), nail spacing 100 mm. No nailing should be visible after installation.

The base can be wood paneling, wood elements, or plywood designed to limit movement at joints, for example, by being equipped with clapboard wood panel that fit together well. TopTite 6° can also be easily installed on an old smooth roofing felt. The surfaces of the base should be clean, even, and dry. For the correct panel thickness, refer to table RA HSD/2 in RA Hus 08.

Important!

Store and transport upright. Should be covered when stored outdoors. Must not be stacked.
At temperatures below +10°C, store the roofing felt at room temperature for 1-2 days before roofing.
When laying on old roofing felt, damages/blisters should be repaired for the best result. Cut away, dry, and possibly repair with sealant K-36.
Utöver tillverkarens anvisningar gäller för montering rekommendationer enligt senaste versionen av
AMA Hus apply.
For the best results during assembly, always ensure precision at joints, endings, or pass-throughs. These are the areas with the greatest risk for potential future moisture problems.